| Customization: | Available |
|---|---|
| Capacity: | 10FT 20FT 40FT |
| Certification: | ISO Tank |
|
Still deciding? Get samples of US$ 11900/Piece
Request Sample
|
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
| Specifications - T11 iso tank container | ||
| Frame Dimensions (L x W x H) | 6058,12192 x 2438 x 2591 mm | |
| Nominal Capacity | 25000,47000 litre (±0.75%) | |
| Maximum Gross Mass | 36000,75000 kgs | |
| Tare Mass | 3510,6200 kg (± 3%) | |
| Design Temperature (Frame & Tank) | -40 to +130 °C | |
| Pressure | Working | 1.70 bar |
| Test | 2.65 bar | |
| Material | Tank (Shell & Ends) | SANS 50028-7 Type 1.4402/1.4404 (C≤0.03%) |
| Frame | SPA-H or equivalent | |
| Insulation | Shell | Rockwool (50kg/m3) 50mm thick on aluminium foil. |
| Ends | Glasswool (16kg/m3) thickness to suit on aluminium foil. | |
| Steam Heating |
6 runs. 110mm width stainless steel 304. 1" BSP inlet, 1" BSP outlet both with captive caps and cable. 4 bar working pressure, 6 bar test with warning decals and markings. A condensate drain is fitted. |
|
| Manhole | 500mm low profile, 8 point fixing with Super Tanktyt Lid seal. | |
| Safety Relief Assembly |
1-off. 2½" BSP Supermaxi Highflow relive, without flameproof gauze. Pressure only set at +4.4 bar (63.8psi). The assembly is situated off centre on a tangential tank pad. |
|
| Air Inlet assembly |
DN 40 ball valve terminating with 1½" BSP connection and cap. The assembly is situated off centre on a tangential tank pad. |
|
| Top Discharge | DN80 stainless steel 316 tank pad with a blind flange. The assembly is fitted on centre on a horizontal tank pad. |
|
| Bottom Discharge |
DN80 45° Univalve Internal Footvalve part no. TBC fitted with an integrated butterfly valve terminating with a 3" BSP spigot with 3" BSP blind cap and chain. |
|
| Thermometer | A surface mounted analogue type is fitted to the rear end dished end of the tank. Dual scale -40°C to +160°C / -40°F to 320°F. The thermometer is fitted with a protection bar. |
|
| Document holder |
A clear plastic document holder ø110mm is fitted to the rear right hand side beam. A drain hole is provided at the lowest point. |
|
| Calibration | A calibration plate marked in cm/litres is fitted on the spillbox side wall. No calibrated stainless steel grade dipstick and bracket fitted. |
|
| Design Code | ASME VIII DIV. 1 | |
| Approval | IMDG, US DOT CFR 49, RID/ADR, CSC, TC, TIR / Customs, UIC, ISO 1496/3 | |
){kind=link}